NC Heater NCH 200V-1KW

Non-contact heating/ quick rise of temperature/ compatible with inert gas/ highly durable

Our NC Heater is used in:

・Soldering of surface mount parts
・Heat source of heat shrink tube
・Heat source for caulking of thermoplastic resin
・Preheating of cans before printing
・Linear heating of coreless coils on coiling machine
・Heat drying of adhesives
・Silver brazing of medical devices
・Heating of liquids


*In the range of AC100V-100W to AC200V-3KW we are prepared to make a customized NCH heater in accordance with your specific requirements for heater capacity, configuration, dimensions, materials, shape of glass tube.

SUS BASE&LONG,MIDDLE SHEATH NCH-IML(200/1000)


SUS BASE&LONG,MIDDLE SHEATH NCH-IML(200/1000) Dimensions


SUS BASE&LONG,MIDDLE SHEATH NCH-ⅡML(200/1000)


SUS BASE&LONG,MIDDLE SHEATH NCH-ⅡML(200/1000) Dimensions


SUS BASE&LONG,MIDDLE SHEATH NCH-ⅢMM(200/1000)


SUS BASE&LONG,MIDDLE SHEATH NCH-ⅢMM(200/1000) Dimensions


Remarks

■ Air/gas piping
Prior to use of NC heater, it is necessary to depressurize air/gas piping system including cylinders in order to secure proper control of hot air flow rate.

■Electric power supply - voltage
When a rated voltage of electric power is used, there is no need to adjust voltage provided that specified minimum flow rate of gas must be maintained. In general, it is recommended to use voltage regulator to adjust the temperature.

■Precautions
・ Use air or inert gas (N2, Ar, etc.) only. 　(Never use flammable gas.). ・ When using a compressor, be sure to filter to remove oil and water.
・ As a routine be sure to perform the sequence of “Fluid ON → Power ON → Power OFF → Fluid OFF” so that fluid is always there when powered electrically.
・ The minimum flow rate (e.g. 15ℓ/min or more at 100V-350W) varies depending on the heater type. Please consult if a low flow rate is desired.

Copyright(c)Toyo Technical Co., Ltd. All Rights Reserved.